JUUS (Juice) - Portable JUUL charger/ Pod Storage by JoeyCahill

Last crawled date: 3 years, 1 month ago

JUUS!
Juice is a Personal Project I figured I would share. This is designed to charge a JUUL e-cig while also allowing you to carry around your pods freely.
Parts Needed:
-JUUL Charger: $5.99 (can use the charger your JUUL came with)https://www.juulvapor.com/shop-juul/#usb
-Dynex Portable Charger: $6-$10https://www.bestbuy.com/site/dynex-2000-mah-portable-charger-orchid-pink/4208518.p?skuId=4208518&cmp=RMX&extStoreId=893&ref=212&loc=1&ksid=3360cc0e-85c8-4892-84b3-4a809769613c&ksprof_id=3&ksaffcode=pg252487&ksdevice=c&lsft=ref:212,loc:2&gclid=CjwKCAiAlL_UBRBoEiwAXKgW50uPLSEUmGk6ix-r_Ybuk7-8j7Yrs7WsJRkcZ5P2lc9IND_isRg0BRoC9f4QAvD_BwE
After Printing
-Once the 3 Parts are printed you need to open up the Dynex Charger and strip away any of the plastic on it so you are left with just the electronics
-Charge the battery fully and then plug your JUUL charger into the USB port on the battery
-Clear any stringing inside the body of the JUUS and then stick the battery into the tall opening on the bottom of the JUUS keeping the JUUL charger facing the JUUL slot opening on the JUUS (Will post pictures later)
-Your JUUL should now be able to slide into the JUUL slot on the JUUS and connect right to the magnet on the charger
-Cap the bottom with the "JUUS_Bot" cap (Remove the cap when its time to charge the actual battery)
-Place pods in the pod storage and then cap that off with the "JUUS_Lid" slider
Extras!
The JUUS was designed to work with the JUUL sleeves I also Designed
(Pictured on the JUUL above)
Check out the 4 different styles!https://www.thingiverse.com/thing:2634745