Thingiverse
JST-PH 2.0 header for TinyWhoop 1S 200maH LiPo by 171MarsMaker
by Thingiverse
Last crawled date: 4 years, 7 months ago
Print this battery header as a replacement when converting your TinyWhoop / Inductrix 1S 200maH battery to JST-PH 2.0 (aka the PowerWhoop connector).
The JST-PH 2.0 connector should provide better electrical contact and power delivery and thus tries to avoid the dreaded shortening flight times of your TinyWhoop as the original Micro-JST 1.25 (aka PicoBlade) battery connector degrades after 30 connects/disconnects.
I have not yet test printed this but it should fit quite nicely.
2016-Nov-11 update: I took time to measure the JST-PH 2 connector and added the notch and better dimensions. Pls print with connector hole facing the bed.
Please share your pictures of your prints and how you installed it on the batteries for others to see.
The JST-PH 2.0 connector should provide better electrical contact and power delivery and thus tries to avoid the dreaded shortening flight times of your TinyWhoop as the original Micro-JST 1.25 (aka PicoBlade) battery connector degrades after 30 connects/disconnects.
I have not yet test printed this but it should fit quite nicely.
2016-Nov-11 update: I took time to measure the JST-PH 2 connector and added the notch and better dimensions. Pls print with connector hole facing the bed.
Please share your pictures of your prints and how you installed it on the batteries for others to see.