JGAurora Magic Bed Height Adjustment Clip

Last crawled date: 4 years, 2 months ago

I purchased a replacement glass build plate for my JGAurora Magic. The bed is the same XY dimensions as the Ender 3. However, the glass plate was much thicker than the original plastic build surface, and the height adjustments for the bed could not compensate. Others had adapted to the glass plate by physically moving the Z limit switch to raise the zero level of the nozzle, but I wanted to be able to go back and forth easily between the two types of build surface. So, I rendered and printed this simple clip, which can be installed on the flange just above the Z limit switch to raise the nozzle zero level. If you need a slightly different adjustment, simply adjust by setting the appropriate scaling on your slicer.