Jet Fan Gaurd 50MM by EricPrints

Last crawled date: 4 years, 7 months ago

50MM fan is stronger than 40MM fan, print and install this Jet Fan Gaurd to protect the spinning blades. The 50MM fan is cooling the 3D Printer electronic RAMPS 1.4 board. Once there was no fan and the motor drivers overheated (summer time, max power to the motors) and the printer shut down, now the 50MM fan cools.
-Mounts to 50mm fan
-Uses M4 screws
Blogspot (specific link about this item)http://ericprints.blogspot.com/2017/01/jet-fan-gaurd.html
Blogspot (3D Printing and similar)http://ericprints.blogspot.com/