Thingiverse
Jersey Jack Pinball - Pirates of the Caribbean "2X" Target Support
by Thingiverse
Last crawled date: 5 years, 9 months ago
Small clip to help keep the 2x target pointed down. This target is unable to use normal target splits due to the tight nature of its location.
By using this you can significantly reduces airballs and also help stop cracking on the subway plastic.
Install instructions
You will need to bend your target support forward as shown in one of the pictures.
Ideally your target should not be touching the subway at all.
Install the support while the target is removed.
You will need to compress the target to the rear target support when reinstalling.
You will also need to readjust the target leaf sensitivity.
You may need to file off a small amount of plastic on the bottom of the red target plastic so it clears the playfield easily.
Printing: no supports required.
By using this you can significantly reduces airballs and also help stop cracking on the subway plastic.
Install instructions
You will need to bend your target support forward as shown in one of the pictures.
Ideally your target should not be touching the subway at all.
Install the support while the target is removed.
You will need to compress the target to the rear target support when reinstalling.
You will also need to readjust the target leaf sensitivity.
You may need to file off a small amount of plastic on the bottom of the red target plastic so it clears the playfield easily.
Printing: no supports required.