Thingiverse
Jeep JK toggle switch holder by younger
by Thingiverse
Last crawled date: 4 years, 8 months ago
This part is designed to hold standard round toggle switches in the coin tray in front of the 4wd lever. I recommend removing the rubber liner then using double sided sticky tape to secure it to the tray.
My goal was a removable switch block that didn't make holes in the factory plastic. I suppose if you were so inclined you could run a small screw through the bottom to secure it, you would have to drive the screw through the hole intended for the switch.
My goal was a removable switch block that didn't make holes in the factory plastic. I suppose if you were so inclined you could run a small screw through the bottom to secure it, you would have to drive the screw through the hole intended for the switch.