Thingiverse
Ipad holder by Roffe1440
by Thingiverse
Last crawled date: 4 years, 10 months ago
This is an Ipad/tablet holder made for my Ipad Pro and Iphone. Its easy to use and works ok.
I made it since I am an archery coach and I use different types of software om ny iPad/Iphone and I wanted a holder that worked for both devices. I have two types of bullheads on my tripods. One is Arca Swiss and the other one is Manfrotto. So I made two holders. I have used it for some time and it works well.
However. You are using the holder on your own risc. I will not replace any broken iPads/tablets/phones/iphones. Make sure that you have secured the tablet/phone properly, you don't have over tighten the screws. If you have any problems please contact me so I can improve the design.
You have to print one of the holder files. It includes bottom and top.
You need two Screws, ie nut holders.
You need the following
2 pieces M5 nut.
1 threaded rod M5. Length approx. 36 cm or 14 inches.
You can make it shorter if you like. Just make sure its easy to take out your device.
I made it since I am an archery coach and I use different types of software om ny iPad/Iphone and I wanted a holder that worked for both devices. I have two types of bullheads on my tripods. One is Arca Swiss and the other one is Manfrotto. So I made two holders. I have used it for some time and it works well.
However. You are using the holder on your own risc. I will not replace any broken iPads/tablets/phones/iphones. Make sure that you have secured the tablet/phone properly, you don't have over tighten the screws. If you have any problems please contact me so I can improve the design.
You have to print one of the holder files. It includes bottom and top.
You need two Screws, ie nut holders.
You need the following
2 pieces M5 nut.
1 threaded rod M5. Length approx. 36 cm or 14 inches.
You can make it shorter if you like. Just make sure its easy to take out your device.