Thingiverse
Improved ReprapDiscount Hall Effect Mount for Makerslide / Ord printers by spelleti
by Thingiverse
Last crawled date: 4 years, 7 months ago
These are some mounts I made by modifying GearNut's original mounts. These mounts have a small plug in the end of the groves that hold the sensor, to help prevent the sensor from moving around.
I have also added a 1mm thick tab to the back of the mount to help people print these on printers that have a moving print bed. I found that the oscillation of the bed during printing made it difficult to complete the print of the original mount without it loosing adheasion with the bed and falling over part way through the print. Once the print has cooled, the tab can be easily snapped off of the mount.
I plan on modifying this mount further by adding a slight groove in the back of the mount to prevent the connector pins from blocking the sensor board as it slides into the mount.
I have also added a 1mm thick tab to the back of the mount to help people print these on printers that have a moving print bed. I found that the oscillation of the bed during printing made it difficult to complete the print of the original mount without it loosing adheasion with the bed and falling over part way through the print. Once the print has cooled, the tab can be easily snapped off of the mount.
I plan on modifying this mount further by adding a slight groove in the back of the mount to prevent the connector pins from blocking the sensor board as it slides into the mount.