IKEA SKÅDIS Pegboard to IKEA BROR Trolley Mounts

Last crawled date: 5 years, 2 months ago

This is pretty simple, I needed a trolley to be able to get some tools out and move them around but I also had this spare IKEA pegboard. A couple of iterations of 3D printed mounts I have combined the two like an IKEA Voltron if IKEA was just a body and one leg.
Always room for improvement but the IKEA pegboard has slots more than holes so you have some room to move it a little. I used some 20mm M5 screws and have adjusted from my original design to give a little more room to tighten the nut + add the washer on the back. Im using 2 flat pieces and 2 top mounts but you can always add a couple more wherever you have your shelf for more support to spread the load if you are concerned about how much weight is on your pegboard (also if you noticed it bending at the top).
You probably need supports for the reworked top mount but I did run the test simulations in Fusion360 this time to improve it a little.