Thingiverse
HYPERLOW AIRSHOT DUAL CAMERA MOUNT by Hyperlow
by Thingiverse
Last crawled date: 4 years, 8 months ago
DEC 15 2020: Added Couch version to fit any model and allow strap to run front to back, or around sides.
NOV 18 2020: Added a softmount version for the H8
NOV 16 2020: Loosened up the H8 mount slightly.
This WIP dual mount design ensures both cameras are locked to same tilt with the goal being to assist in GoPro framing. Particularly useful when filming in the narrower 4:3 Linear mode on the GoPro which has much smaller FOV than DJI's FPV feed.
When used along with DJI's OSD framing guide you can always be sure you are capturing the subject in your shot despite any angle adjustments made during shooting.
If you just fly freestyle and wider modes, you probably wont get much use out of it. But if chasing a subject while filming for a Reelsteady passthrough then it's aimed at you.
Additional hardware needed:
40mm m5 bolt [eg. https://tinyurl.com/y4buggp2]
M5 locknut
Parts:
Two side mounts
One Hero 8, or Hero 5/6/7 center dual mount
Two standoff sleeves (these provide side support for DJI cam)
Any remixes should follow Hyperlow [Frame Name] Dual Camera Mount naming convention.
Please leave feedback. This approach can probably be finessed in the future with pilot input and time.
P.S. have not been able to test fit the Hero 8 yet
NOV 18 2020: Added a softmount version for the H8
NOV 16 2020: Loosened up the H8 mount slightly.
This WIP dual mount design ensures both cameras are locked to same tilt with the goal being to assist in GoPro framing. Particularly useful when filming in the narrower 4:3 Linear mode on the GoPro which has much smaller FOV than DJI's FPV feed.
When used along with DJI's OSD framing guide you can always be sure you are capturing the subject in your shot despite any angle adjustments made during shooting.
If you just fly freestyle and wider modes, you probably wont get much use out of it. But if chasing a subject while filming for a Reelsteady passthrough then it's aimed at you.
Additional hardware needed:
40mm m5 bolt [eg. https://tinyurl.com/y4buggp2]
M5 locknut
Parts:
Two side mounts
One Hero 8, or Hero 5/6/7 center dual mount
Two standoff sleeves (these provide side support for DJI cam)
Any remixes should follow Hyperlow [Frame Name] Dual Camera Mount naming convention.
Please leave feedback. This approach can probably be finessed in the future with pilot input and time.
P.S. have not been able to test fit the Hero 8 yet