Thingiverse
HyperLite Superstrong Pod by Engineer_Fpv
by Thingiverse
Last crawled date: 4 years, 7 months ago
For the hyperlite evo/ss
Must print in TPU
m3 screws with 7-10mm long( can use m3 nuts, i never actually did).
I have been using a unify vtx and i have my antenna(aomway) inside the pod, you can use any antenna as you like with a pigtail, or you can have in on the bracket as stock.
Foxeer hs1177 camera mounted with the U bracket in the middle screw.
2.5mm foxeer lens.
The lens/camera are fully protected from the pod and no surroundings
It took some really good crashes, Super strong
Strap for the gopro mount 28cm
The gopro mount will be in the link under as i remix it from another designer
LINK : https://www.thingiverse.com/thing:2747196
Leave a comment if you would me to change anything
If you like the design and find it very useful you can leave me a tip
Must print in TPU
m3 screws with 7-10mm long( can use m3 nuts, i never actually did).
I have been using a unify vtx and i have my antenna(aomway) inside the pod, you can use any antenna as you like with a pigtail, or you can have in on the bracket as stock.
Foxeer hs1177 camera mounted with the U bracket in the middle screw.
2.5mm foxeer lens.
The lens/camera are fully protected from the pod and no surroundings
It took some really good crashes, Super strong
Strap for the gopro mount 28cm
The gopro mount will be in the link under as i remix it from another designer
LINK : https://www.thingiverse.com/thing:2747196
Leave a comment if you would me to change anything
If you like the design and find it very useful you can leave me a tip