Thingiverse
HyperCube Reinforced 12mm Z-Axis Rod Bracket by Nase00
by Thingiverse
Last crawled date: 4 years, 10 months ago
Note: This intended for the original HyperCube with a single Z-axis motor. It's probably not relevant to any HyperCube Evolved designs.
This is a bracket for holding the bed to a 12mm smooth rod in a way that should hopefully reduce sag. It also replaces the two rear bed supports, since it extends past where the original ones are mounted.
You may need to have longer extrusion pieces (300mm) on the bed to have room for the rear M5 mounting screws. Otherwise, there is an additional M5 screw hole in the middle of the bracket.
This is a bracket for holding the bed to a 12mm smooth rod in a way that should hopefully reduce sag. It also replaces the two rear bed supports, since it extends past where the original ones are mounted.
You may need to have longer extrusion pieces (300mm) on the bed to have room for the rear M5 mounting screws. Otherwise, there is an additional M5 screw hole in the middle of the bracket.