Thingiverse
Hyperbolic paraboloid
by Thingiverse
Last crawled date: 5 years, 10 months ago
This is a hyperbolic paraboloid with incorporated supports.
Adjust resolution as shown in the pictures: from 0.05mm to 1mm or whatever works for you.
Turn thin walls off and select a middle slicing tolerance.
Use a raft with 0mm air gap.
Additional supports for the middle may be needed if you want a really smooth bottom side, but it prints just fine without them.
Adjust resolution as shown in the pictures: from 0.05mm to 1mm or whatever works for you.
Turn thin walls off and select a middle slicing tolerance.
Use a raft with 0mm air gap.
Additional supports for the middle may be needed if you want a really smooth bottom side, but it prints just fine without them.