Huawei P8 Lite 2017 Bumper Case by DruckiMCDruck

Last crawled date: 3 years ago

General
I couldn't find a bumper case for my Huawei P8 Lite 2017, so i decided to create my own. Note that this doesn't fit the old P8 Lite, but only the 2017 version. It's a single piece which just gets snapped directly onto the phone. The part shown above was printed in green PLA.
Since it has to be printed with supports, expect a bit of cleaning of the inner surfaces before you can put it onto your phone.
How to fit it onto your phone
See above for photos of the steps described here.
After printing and cleaning, get your phone and insert it with the top end first. Push it as far up as possible.
Next, get the lower right edge of the phone into the bumper. To do this, pull the lower right corner of the frame to the right (until the lower right corner of the phone is almost at the USB cutout) and push it in.
Finally push the lower left corner into the bumper. This might take a bit of force, as the bumper has a very tight fit.
....
Profit!
PS:
Yes, the shattered screen made me think about getting a bumper in the first place ;)
Feel free to modify, remix or alter this part in any way, just give credit where credit is due.