Thingiverse
HP Power Supply End Cap DPS-800GB A by hearnia_2k
by Thingiverse
Last crawled date: 4 years ago
This is a work in progress! Not properly tested/implemented!
This is my first item I have shared. I could not find an end-cap that would work for this particular power supply, and I plan to use this PSU as an upgrade/replacement for my Anycubic Linear Plus.
At present this does not have any holes placed to allow for cable entry, as I have yet to decide which direction/location my cables will exit from. Additionally I plan to create something for the other end as well, but I have not decided if this would be just a small band to make the power supply sit flat on a surface, or perhaps it will cover the rear in the same way, and maybe therefore I would incorporate a switch location too.
Any suggestions are welcome. I'm very much learning how to do the cad work right now, too, so trying to keep this design simple.
This is my first item I have shared. I could not find an end-cap that would work for this particular power supply, and I plan to use this PSU as an upgrade/replacement for my Anycubic Linear Plus.
At present this does not have any holes placed to allow for cable entry, as I have yet to decide which direction/location my cables will exit from. Additionally I plan to create something for the other end as well, but I have not decided if this would be just a small band to make the power supply sit flat on a surface, or perhaps it will cover the rear in the same way, and maybe therefore I would incorporate a switch location too.
Any suggestions are welcome. I'm very much learning how to do the cad work right now, too, so trying to keep this design simple.