Thingiverse
HotShotII Battery Cover Attachment D7 by Qbee
by Thingiverse
Last crawled date: 4 years, 6 months ago
Replacement for the HotshotII part D7.
Not a carbon copy, as that would be very impractical to print, but a drop in replacement.
The flat side needs to be on the print bed. The rounded side needs to be on top when installing otherwise there will not be enough clearance to fit. Make sure to properly clean the protruding stubs as they are a tighter fit than the original. This is due to the 3D printing process and can be improved with smaller layer heights.
All in all in the part fits a bit more snugly than the original.
Screwing in the self-tapping Tamiya screws could require a bit more torque than for the original part, but this also depends on the type of print material.
Not a carbon copy, as that would be very impractical to print, but a drop in replacement.
The flat side needs to be on the print bed. The rounded side needs to be on top when installing otherwise there will not be enough clearance to fit. Make sure to properly clean the protruding stubs as they are a tighter fit than the original. This is due to the 3D printing process and can be improved with smaller layer heights.
All in all in the part fits a bit more snugly than the original.
Screwing in the self-tapping Tamiya screws could require a bit more torque than for the original part, but this also depends on the type of print material.