Hoover Adaptor by dasuitcase

Last crawled date: 3 years ago

Simple adaptor for bandsaw hoover/vacuum connector, set your nozzle size, copes with tapers and away you go
length is depth of socket on tool,
flange width is probably fine at 5mm
outer is diameter of socket on tool
inner 1 is the smallest taper size
inner 2 is largest taper size
this is our makerspaces chop saw adaptor as an example, should be print ready.
// takes depth of socket, width of flange needed, internal diameter of socket, diameter of small end of hose, diameter of larger end at the depth of socket position
HooverAdaptor( 28, 5, 35.6, 31.25, 33.25 );
Enjoy