Honeycomb Key Holder

Last crawled date: 4 years, 3 months ago

I wanted one of these for my keys, so i am printing this tonight - i was lazy to make my own so i found one that i remixed from Dalton32S.
I remixed it because in the original where the two honeycombs laying next to each other touched there was a double wall, and i felt it needed to remain a single wall other wise it felt that that particular inner wall was too thick.
Then i added some more honeycombs and made some where they are closed at the back - purely for aesthetic reasons.
Finally the piece that is attached to your keys - i carved out 3 different images of bees, just thinking that it might look nicer on your key than a plain hexagon.
Anyways, here it is with MANY thanks to Dalton32S for the original.
With printing - i would just print this flat on the bed, you probably have to rotate them - and make sure there are no supports - raft etc, that would just make it hard to clean up and be a waste.