Thingiverse
Holley Terminator 3.5" Screen Mount - EZ supports and gauge pod mods by ruse_cruise
by Thingiverse
Last crawled date: 4 years, 8 months ago
-Cleared out the reverse side of the hose clamp slot for printers with difficult breakaway supports EG stratasys.
-Added additional wire bend clearance on reverse
-Other measurements and fillets to taste
-Added gauge pods - either glue-on if you've already printed the original, or print together
-Left, right, and dual pod versions
12/22/20 - Added simple glue-on visor
NOTES: My printer is dead nuts on hole diameters. You may need to open the holes up a little if your printer runs small.
-Added additional wire bend clearance on reverse
-Other measurements and fillets to taste
-Added gauge pods - either glue-on if you've already printed the original, or print together
-Left, right, and dual pod versions
12/22/20 - Added simple glue-on visor
NOTES: My printer is dead nuts on hole diameters. You may need to open the holes up a little if your printer runs small.