Thingiverse
High Temp and Stringing Test
by Thingiverse
Last crawled date: 6 years, 2 months ago
Moving to PETG/ABS/Other filaments that have higher temp requirements this will give you a higher temp tower to use. You can see in my pic that I used this for PETG to get it dialed in.
I have included my Gcode, however this does include use of ABL so you may need to tweak based on your configuration.
If you are doing this yourself in a slicer, I can help with Cura. You utilize Extensions -> Post Processing -> GCode and then you utilize the ChangeAtZ setting to change the height at 29, 49, 69, 89, 109, 129, 149, 169, 189.
I have included my Gcode, however this does include use of ABL so you may need to tweak based on your configuration.
If you are doing this yourself in a slicer, I can help with Cura. You utilize Extensions -> Post Processing -> GCode and then you utilize the ChangeAtZ setting to change the height at 29, 49, 69, 89, 109, 129, 149, 169, 189.