Thingiverse
High Clearance CR10 OEM Fang Mod by Tacblades
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a remix of the awesome Racush OEM Fang Mod for the Creality CR-10 & CR-10s
It gives great access and visibility of the print head while printing.
Uses all existing standard parts, no new parts needed.
The original the fangs are very close to the bed about 1mm, and in some print where I had curl on edges it was catching the printed part.
So this is a re-mesh
Shortened the fangs by about 5mm height
Re angles the jets to ensure the air just are exactly on the printed part nozzle end
Made the aperture at the end for the nozzle smaller to direct the air jets more precisely
Files Included:
Simplify3d master file
Simplify3d Support export file
gcode for a CR-10 Printer in PLA 204deg nozzle and 60deg bed
Simplify3d Profile
STL of just the fang
NOTE: if you use the gcode, make sure there is no bed clips 7cm in both directions from the front left corner of the build plate.
You can print this without supports but it does come out a lot nicer with them.
All Tacblades designs are tested and printed before posting. All designs and created with 3d printing from the beginning so minimal support and angles designed to print easily.
It gives great access and visibility of the print head while printing.
Uses all existing standard parts, no new parts needed.
The original the fangs are very close to the bed about 1mm, and in some print where I had curl on edges it was catching the printed part.
So this is a re-mesh
Shortened the fangs by about 5mm height
Re angles the jets to ensure the air just are exactly on the printed part nozzle end
Made the aperture at the end for the nozzle smaller to direct the air jets more precisely
Files Included:
Simplify3d master file
Simplify3d Support export file
gcode for a CR-10 Printer in PLA 204deg nozzle and 60deg bed
Simplify3d Profile
STL of just the fang
NOTE: if you use the gcode, make sure there is no bed clips 7cm in both directions from the front left corner of the build plate.
You can print this without supports but it does come out a lot nicer with them.
All Tacblades designs are tested and printed before posting. All designs and created with 3d printing from the beginning so minimal support and angles designed to print easily.