Hictop D3 Hero cooling shroud

Last crawled date: 4 years, 3 months ago

This is a double sided cooling shroud for the Hictop IDEX printer, when printing anything with overhangs, you need cooling from both sides, or you will have a uneven print.
Make sure to use I higher temp plastic. DO NOT USE PLA.
Make sure when removing fan screws to loosen them with extruders in the middle of the bed, there is small nuts that are attached to the screw(they will fall and be lost forever). When putting back together, you will reverse the bolt to where the nuts are on the outside. I used a piece of tape to hold in the bolts then remove the tape so i can fit in the allen to tighten. Nuts are a 4mm. I think the allen is a 1.5mm.
Use supports only from the build table!