Hictop control panel back cover by styk

Last crawled date: 3 years ago

I remixed the original design to cut filament usage by adding holes to the rear portion.. Since the primary purpose for me was to keep static laden fingers away from the electrostatic sensitive electronics this is not an issue. I ran out of the supplied tape in the kit and switch to some unknown brand masking tape. it started lifting shortly after the print started. I turn off the bed heat so i wouldn't loose bed adhesion and let it finish. However this resulted in some warp-age. I lengthened the SD card access by 3mm towards the bottom. the warp-age doesn't really affect the function. In other words, no need to reprint if you don't want to