Thingiverse
HG P407 rear shock mount adapters
by Thingiverse
Last crawled date: 5 years, 10 months ago
A set of coil-over shock adapters for the HG P407.
The STL files are set up for shocks that are 90mm eye-to-eye and 15mm in diameter. The OpenSCAD files allow you to customize these measurements for your particular setup.
Hardware needed:
2x M3x12 machine screws
1x M3x20 machine screw
3x M3 hex nuts
Installation steps are provided in the photos.
The STL files are set up for shocks that are 90mm eye-to-eye and 15mm in diameter. The OpenSCAD files allow you to customize these measurements for your particular setup.
Hardware needed:
2x M3x12 machine screws
1x M3x20 machine screw
3x M3 hex nuts
Installation steps are provided in the photos.