Thingiverse
Hellhound blade for OTF switchblade
by Thingiverse
Last crawled date: 6 years, 7 months ago
One more blade for David6722's OTF switchblade. This one is based on the Microtech Hellhound. I really don't plan to make a career out of plastic knives, I just couldn't pass this one up.
See the original thing for the rest of the pieces and instructions. This blade should replace the standard one with no changes. (It's a little shorter, to keep it from looking skinny.)
Printing
The blade comes in single- and double-sided versions. The single-sided blade prints with no support, and the double-sided version needs support.
You can print the double-sided version on its side. You can also print it lying on its spine, with the edge facing up, with a raft. The "off" side of the blade comes out much cleaner, though the spine and holes need cleanup.
If you print the blade with a high infill setting, you get a more satisfying sound and feel when it snaps open.
See the original thing for the rest of the pieces and instructions. This blade should replace the standard one with no changes. (It's a little shorter, to keep it from looking skinny.)
Printing
The blade comes in single- and double-sided versions. The single-sided blade prints with no support, and the double-sided version needs support.
You can print the double-sided version on its side. You can also print it lying on its spine, with the edge facing up, with a raft. The "off" side of the blade comes out much cleaner, though the spine and holes need cleanup.
If you print the blade with a high infill setting, you get a more satisfying sound and feel when it snaps open.