Hedgehog With Feet by FireDraakon

...g4 cube feet with big feet by stealer0517 thingiverse g4 cube feet with bigger feet and support

...g4 cube feet with feet and support by stealer0517 thingiverse smaller feet bigger support

...cator 7 fits over the existing rubber feet or can replace rubber feet by removing rubber feet and screwing on to base of printer.

...kirby with feet - remix thingiverse kirby with feet

...dickfish on feet by syzguru11 thingiverse dickfish on feet

...keyboard feet by juliocastro thingiverse keeboard feet

...keyboard feet by lukkos thingiverse keyboard feet

...zmr250 feet by pupuyang thingiverse zmr250 feet

...feet for simp metal by will_corp thingiverse feet

...troll feet by richwhite thingiverse troll feet

...ll for 40mm x 40mm x 20mm fans such as extruder cooling fans. one version only has retainers, the second has two mounting holes.

... it flat with the led holders facing upward. leds snap in without glue (though it isn't a bad idea). uses standard m3 screws.

... and holder of some kind, it allows you to adjust the point at which the bed is zeroed. note: the endstop holder is not included.

...hedgehog by xeontiger thingiverse hedgehog v1 hedgehog v2

...hedgehog by erikfurton thingiverse a hedgehog. i like hedgehogs

...house with hedgehog thingiverse this is a house with a hedgehog.

...hedgehog by paninithecat thingiverse a wall pannel of a hedgehog.

...hedgehog sitting thingiverse this was modeled on hedgehog sitting on hand.

...hedgehog by hp012003 thingiverse hedgehog-penci (test scale)

...hedgehog by jnastuk thingiverse free hand scan of hedgehog art

...hedgehog by tomi_3d thingiverse hedgehog! printed with craftbot! sliced with craftware!

...ngiverse it's autumn again in europe and there are lots of hedgehogs about. this fat little hedgehog prints without support.

...hedgehog by qrcky thingiverse low polygon hedgehog model in 3d max

...g4 cube feet with big feet by stealer0517 thingiverse g4 cube feet with bigger feet and support

...g4 cube feet with feet and support by stealer0517 thingiverse smaller feet bigger support

...lready out there to have feet at the bottom so it doesn't tip over while printing and just for a better footing on the table.

...kirby with feet - remix thingiverse kirby with feet

...dickfish on feet by syzguru11 thingiverse dickfish on feet

...keyboard feet by juliocastro thingiverse keeboard feet

...keyboard feet by lukkos thingiverse keyboard feet

...zmr250 feet by pupuyang thingiverse zmr250 feet

...troll feet by richwhite thingiverse troll feet