Thingiverse
Header Pin Back Block by BrianM
by Thingiverse
Last crawled date: 4 years, 1 month ago
A simple design to create a back shell for Polarized Header Pins
so they can be used in-line.
Script allow selection of several parameters but the important
ones are;
Number of Pins
Length of back shell
Radius of hole
I have tested 2, 3 and 4 pins but haven't tried any thing bigger.
Solder the wires to the pins, heat shrink for support, then a little epoxy to hold it all in place.
Print and Enjoy.
so they can be used in-line.
Script allow selection of several parameters but the important
ones are;
Number of Pins
Length of back shell
Radius of hole
I have tested 2, 3 and 4 pins but haven't tried any thing bigger.
Solder the wires to the pins, heat shrink for support, then a little epoxy to hold it all in place.
Print and Enjoy.