Thingiverse
Hardcore 44 Session-Foxeer Mini Mount by claytonbakerjr
by Thingiverse
Last crawled date: 4 years, 3 months ago
This is a remix of Zanthor's original HC38 mount.
I did some editing to allow the Foxeer Predator Mini
to have a better fit and opened up an area in the rear for
a wire way. Also opened up the FOV for the Foxeer.
I also opened up the session hole to allow for a less snug fit.
My original thought was to print this off in ABS but after researching it seems
they should be made with TPU. I may in this case tighten up the session
hole alittle since the TPU will flex to fit.
I just adjusted the Session opening to be a little smaller than the original. Its named the same with TPU on the end. This has not been test printed as of now
I did some editing to allow the Foxeer Predator Mini
to have a better fit and opened up an area in the rear for
a wire way. Also opened up the FOV for the Foxeer.
I also opened up the session hole to allow for a less snug fit.
My original thought was to print this off in ABS but after researching it seems
they should be made with TPU. I may in this case tighten up the session
hole alittle since the TPU will flex to fit.
I just adjusted the Session opening to be a little smaller than the original. Its named the same with TPU on the end. This has not been test printed as of now