Handle for Croozer cargo trailer by Robert_W

Last crawled date: 4 years, 4 months ago

This is a handle for an old Croozer cargo trailer.
The hitch arm of the old cargo trailer has two possible positions.
The lower position is used if the cargo trailer is used in combination with a bicycle.
In the upper position the cargo trailer can be used as a handcart.
Note:
The handle can not be used for newer Croozer cargo trailers because the coupling system of the newer cargo trailers use a different coupling system.
The coupling system of the old cargo trailers have a square shape with approx. 15,7 x 15,7 mm.
Version 3
Use this version if you want to print the handle in the upright position on the plate.
This version gives a nicer surface.
The hole for the lock is increased to 6.6 mm because of the upright position (this is the only difference comapared to V2).
I recommend to use extra support under the 45° part as shown in the picture. Otherwise reduce the print speed dramatically (more as 50%). Otherwise this part may drop on the building plate. Use support on build plate and also enforcers
Version 2
Use this version if you to print the handle laying on the side.
The surface is not as nice as for version 3.
The hole for the lock is 6.4 mm
Prints al little faster
Use support on build plate