Thingiverse
Hamster bridge by webdevvie
by Thingiverse
Last crawled date: 5 years, 4 months ago
A hamster bridge, made for my own hamster's habitat. Spans a 39/38/30/20cm gap depending on which parts you print. You could probably extend it even further.
This is meant for a russian dwarf hamster. Not tested with anything bigger.
You can see it printed here:https://www.youtube.com/watch?v=cATJvFSNm-Q
IMPORTANT
After glueing DO NOT put it in your hamster's habitat UNTIL the glue fumes are long gone. The fumes can severely hurt your furry pal! Also print this in PLA as the gasses given off by ABS are toxic! Print at your own risk!
This is meant for a russian dwarf hamster. Not tested with anything bigger.
You can see it printed here:https://www.youtube.com/watch?v=cATJvFSNm-Q
IMPORTANT
After glueing DO NOT put it in your hamster's habitat UNTIL the glue fumes are long gone. The fumes can severely hurt your furry pal! Also print this in PLA as the gasses given off by ABS are toxic! Print at your own risk!