H-King Color 250 / Diatone 250 Nylon by tbraber

Last crawled date: 3 years ago

This is my customization of the Hobby king Color 250 frame also known as Diatone 250 Nylon PET
This means the frame is a not 3D printed.
The Frame can be purchased from Hobbyking or Banggood and is very cheap, about 10 euro.
UPDATE 20-2-2016: Added 22mm height version.
UPDATE 17-8-2016: Created version 2
Because the transmitter I choose did not fit in the 20mm height version I created a new one for 22mm spacers (the ones with 22 in the name).
One side panel also has a switch opening for switching off the FPV gear.
I used 20mm Nylon spacers that replaces the original ones to make a nice low rider.
The updated version from 20-2-2016 has 22mm height spacers.
Best to fly this one with 6"props with low KV motors like 1900kv or 1500kv with 3S Lipo.
In my setup I use Tarot 2204 1550kv motors and they fly great.
This is a list of parts I used:
Motors: Tarot 2204 1550KV
Props: 6" KingKong 6040
Frame: Diatone 250 Nylon
Flight controller: CC3D with Betaflight
ESC: ZTW Spider 12A flashed with BLheli 14.302
Receiver: FrSky FrSky-X4RSB conected via SBUS
Bleutooth: HC-06
WS2812 Leds: CJMCU WS2812 LED board
XT60 adapter: Blue sky XT60 PCB connector
Spacers Nylon: M3x22mm Nylon Hex Standoff Female/Femal
For FPV I used:
Camera: Eachine-700TVL CMOS
Transmitter: Eachine Racer 250 Spare Part 5.8Ghz 600mw with OSD
I am still working on the FPV part and designing new side protection plates with a hole for a switch to switch off the transmitter if you do want to fly LOS only.
The antenna connector goes through a hole that has to be made in the top plate. The exiting hole is not available anymore because it was to far in the back where the XT60 connector is mounted.