Thingiverse
Gunpla Stand by MechaDane
by Thingiverse
Last crawled date: 4 years ago
Basic scratch-built gunpla stand
Features:
Theoretically cost-efficient over most basic gunpla stands in the market (calculated using mass properties in SOLIDWORKS and assuming <$20 filament)
Supports RG and HG models, although the rectangular mount for RGs is not ready yet
Can hang on walls using the little cutout behind the base part
For full assembly instructions, proceed to this link: http://www.instructables.com/id/3D-Printed-Gunpla-Stand/
Revision 1 (10/21/16, 9:52 PM PST):
Added the rectangular mount for those that require it. My print settings had it at 80% infill
Features:
Theoretically cost-efficient over most basic gunpla stands in the market (calculated using mass properties in SOLIDWORKS and assuming <$20 filament)
Supports RG and HG models, although the rectangular mount for RGs is not ready yet
Can hang on walls using the little cutout behind the base part
For full assembly instructions, proceed to this link: http://www.instructables.com/id/3D-Printed-Gunpla-Stand/
Revision 1 (10/21/16, 9:52 PM PST):
Added the rectangular mount for those that require it. My print settings had it at 80% infill