Thingiverse
Guard Llama (Medium) - 28Chibi by Sidequest_TTM
by Thingiverse
Last crawled date: 4 years, 8 months ago
The terrifying Guard Llamas are the sentinels that watch the edge of a large centaur encampment. Their piercing shrieks and goopy spit are enough to dissuade most goblins from entering.
Sadly not an official entry in the Monster Manual, these were a bit of a joke monster that the DM threw into a session.
This is part of my larger collection, 28 Chibi. 28Chibi is a new generation of minis made to be printed flat on the bed. Inspired by the likes of DutchMogul's DungeonDoll's and GrumpyRobot's FlatMinis, These:
Print quickly and reliably on high- or low-end printers alike.
Are sized for 28mm games such as D&D, Pathfinder, Shadowrun, Starwars EofE etc
Storage is space efficient and safe due to the flat-pack & peg-and-hole base design (The peg is 2x2mm, so if the included base is not to your liking adding a hole to your preferred base is a quick modification.)
The hands are designed for modular equipment, and should generally also accept objects designed in the FlatMini style.
The detail steps up in increments of 0.6mm, allowing for a variety of different layer heights to still print these crisply. 0.2mm is my go to, but higher or lower values (such as 0.1, 0.12 or 0.3) all work great too.
Sadly not an official entry in the Monster Manual, these were a bit of a joke monster that the DM threw into a session.
This is part of my larger collection, 28 Chibi. 28Chibi is a new generation of minis made to be printed flat on the bed. Inspired by the likes of DutchMogul's DungeonDoll's and GrumpyRobot's FlatMinis, These:
Print quickly and reliably on high- or low-end printers alike.
Are sized for 28mm games such as D&D, Pathfinder, Shadowrun, Starwars EofE etc
Storage is space efficient and safe due to the flat-pack & peg-and-hole base design (The peg is 2x2mm, so if the included base is not to your liking adding a hole to your preferred base is a quick modification.)
The hands are designed for modular equipment, and should generally also accept objects designed in the FlatMini style.
The detail steps up in increments of 0.6mm, allowing for a variety of different layer heights to still print these crisply. 0.2mm is my go to, but higher or lower values (such as 0.1, 0.12 or 0.3) all work great too.