Thingiverse
Grease Fitting Cap by The_Cheat
by Thingiverse
Last crawled date: 4 years, 1 month ago
Cap for grease fittings, can fit brake bleeders too but scaling up a little would help with that. They fit very easily but snugly on a grease fitting that has a little grease on it.
I print these sequentially out of Ninjaflex in vase mode, using a .6mm nozzle 1mm layer width. They take 2 minutes per part for me but require a lot of cooling to not blob out. I just ran a couple build plates and I'm set for a while :)
I print these sequentially out of Ninjaflex in vase mode, using a .6mm nozzle 1mm layer width. They take 2 minutes per part for me but require a lot of cooling to not blob out. I just ran a couple build plates and I'm set for a while :)