Thingiverse
GRBL Arduino Uno Parallel Port Case by Chordless
by Thingiverse
Last crawled date: 4 years, 7 months ago
A case i designed to contain an Arduino Uno running GRBL and a parallel port which i needed to interface to my CNC electronics board. You will need 4 M3 bolts about 10mm long to screw the arduino in place. You also need two more M3 screws and two M3 nuts to fasten the parallel port.
The case is designed to hold the parallel port at the exact height needed to plug it into my CNC board, but the Fusion 360 files are provided if you need to make adjustments.
The lid could have been a tighter fit; I might end up having to put some duct-tape on to secure it in place.
The case is designed to hold the parallel port at the exact height needed to plug it into my CNC board, but the Fusion 360 files are provided if you need to make adjustments.
The lid could have been a tighter fit; I might end up having to put some duct-tape on to secure it in place.