Thingiverse
Grabbers by cooasty
by Thingiverse
Last crawled date: 4 years, 7 months ago
A remix of wonderful builds by SirRob. Scaled and added spring loaded button.
Drill HD pivot pin units with a 2 mm drill bit. An index # 50 will give a nice firm hole.. Requires careful use of knife to break loose components. Install filament for pin. Heat pin ends to form a button. Best to use a soldering iron or equal for the side close to the grabber.
LD uses a ball point spring cut down. HD uses a full spring. Install spring, glue button, then position clip and glue. Clip is applied to the bottom to help hold the spring and rod in place.
Work in progress. Stay tuned for additional remixes. Currently improving clearances for easier part separation. Units clearanced:
pliers_HD3
Remix:https://www.thingiverse.com/thing:4633366https://www.thingiverse.com/thing:2874360
Drill HD pivot pin units with a 2 mm drill bit. An index # 50 will give a nice firm hole.. Requires careful use of knife to break loose components. Install filament for pin. Heat pin ends to form a button. Best to use a soldering iron or equal for the side close to the grabber.
LD uses a ball point spring cut down. HD uses a full spring. Install spring, glue button, then position clip and glue. Clip is applied to the bottom to help hold the spring and rod in place.
Work in progress. Stay tuned for additional remixes. Currently improving clearances for easier part separation. Units clearanced:
pliers_HD3
Remix:https://www.thingiverse.com/thing:4633366https://www.thingiverse.com/thing:2874360