Thingiverse
GPU Mining Mount by harryroberts
by Thingiverse
Last crawled date: 4 years, 7 months ago
A simple mount to hold a GPU with a standard riser for mining. Should work for any 2 slot GPU.
The design works by flexing the vertical part back slightly to allow for it to then slide onto the part of the GPU you would normally screw into a PC case. This allows it to rigidly hold the GPU in place with no additional hardware.
You just need to find a suitable way of attaching this mount to your rig. I added some additional "sticky-out bits" off the centre and end section to give more options for attaching this mount to stuff - on my rig I just used duct tape around a few places onto the frame.
Printed in the used orientation, which means you need to do 2 bridges, but they are only short. If you don't print bridges well you may need to use a knife to clean out the slot for the card at the top.
The design works by flexing the vertical part back slightly to allow for it to then slide onto the part of the GPU you would normally screw into a PC case. This allows it to rigidly hold the GPU in place with no additional hardware.
You just need to find a suitable way of attaching this mount to your rig. I added some additional "sticky-out bits" off the centre and end section to give more options for attaching this mount to stuff - on my rig I just used duct tape around a few places onto the frame.
Printed in the used orientation, which means you need to do 2 bridges, but they are only short. If you don't print bridges well you may need to use a knife to clean out the slot for the card at the top.