GoPro style mount for Alunar M508 by OldSalty3D

Last crawled date: 3 years, 1 month ago

Here is a GoPro style of mount for the Alunar M508.
AUTO BED LEVELING SETUP IS REQUIRED!
The bracket will take the place of the front bed leveling springs, so having an auto bed leveling setup is required. Once this bracket is put into place you will no longer be able to adjust the front section of the build plate.
I must also point out that the clearance between the print head and the camera is a tight, so be carfull as to how the camera is tilted. I also recommend doing a dry run (move bed and print head by hand with stepper motors turned off) to make sure you have the clerance so that the print head doesn't slam into the camera, especially during bed leveling.
I CAN'T BE HELD RESPONSIBLE FOR ANY DAMAGE DONE TO YOUR PRINTER WHILE USING THIS BRACKET, USE AT YOUR OWN RISK
With that being said, I highly recommend that you monitor your printer for the first few prints just to make sure that the camera bracket doesn't hit the frame and causing damage to your bed drive belt or stepper motor. I wouldn't install this bracket, then go to bed, or leave the house until after you feel confident that it's not going to damage your printer.