Thingiverse
GoPro hands-free mount for Handy and reinforced Handy prototype mount by bafangit
by Thingiverse
Last crawled date: 4 years ago
These are variants of Handy's V2 prototype hands free mount.
The gopro mount attaches to a small connector piece that attaches to a curved extension arm, which then attaches to the gopro chest mount. This provides a hands free experience for the Handy. Slide the chest mount down as far as needed to position the Handy properly (I usually slide the shoulder straps under my arms). So the chest mount sits on the belly, like a belt, with the curved extension arm pointing toward your feet. I position the Handy with buttons facing me, and sleeve adapter facing away from me. Works best in a reclining position, but I have used it okay in a sitting position, too.
The other mount is for a manfrotto or other 1/4-20 thread tripod connector. It is a remix of Handy's prototype mount with the simple addition of the side rib reinforcements. I had a couple of my prints split there. It might have been poor layer adhesion in my printer, but I added these ribs and haven't had any splits since. If you've already printed Handy's prototype, and haven't had any problem with splitting, I don't think you need to try this version.
The gopro mount attaches to a small connector piece that attaches to a curved extension arm, which then attaches to the gopro chest mount. This provides a hands free experience for the Handy. Slide the chest mount down as far as needed to position the Handy properly (I usually slide the shoulder straps under my arms). So the chest mount sits on the belly, like a belt, with the curved extension arm pointing toward your feet. I position the Handy with buttons facing me, and sleeve adapter facing away from me. Works best in a reclining position, but I have used it okay in a sitting position, too.
The other mount is for a manfrotto or other 1/4-20 thread tripod connector. It is a remix of Handy's prototype mount with the simple addition of the side rib reinforcements. I had a couple of my prints split there. It might have been poor layer adhesion in my printer, but I added these ribs and haven't had any splits since. If you've already printed Handy's prototype, and haven't had any problem with splitting, I don't think you need to try this version.