Thingiverse
Gopro 8 Naked/Lite Flat version V1 and V2 by Beyondgravity
by Thingiverse
Last crawled date: 4 years, 8 months ago
Gopro 8 Naked/Lite Flat version
Things you will need:
Extended gopro 8 sensor flex ribbon (look for it on aliexpress) https://tinyurl.com/vw4fwx6e
Small 5V 2A bec
Small momentary switch (i have used one from fpv camera remote)
Futaba style connector for power
Osmo Action Filters (filter glass needs to be heated up and they pop out easily)
Small antenna wire (follow oscar liang tutorial for attaching antenna for wifi)
14x14mm heatsink that is attached from the bottom
Case is made from pla but you can use petg or whatever suits your needs, sensor holder is made from tpu for suppressing any vibrations getting into the sensor/lens.
Flex sensor ribbon is covered with flexi dip (rubber type coat that hold things in place very well and it can be easily peeled off without damaging the connectors, its also good to keep moisture away.
Edit:
I have change the design a bit for longer sesnor ribbon which can be purchased here
https://www.ebay.co.uk/itm/Extension-Connector-Adapter-45Pin-ZIF-0-3mm-Pitch-FFC-FPC-Flexible-Cable-120mm/124447029580
This design does not require previous slightly longer sensor ribbon and stoc one will do the job perfectrly fine and its 3 times cheaper.
Things you will need:
Extended gopro 8 sensor flex ribbon (look for it on aliexpress) https://tinyurl.com/vw4fwx6e
Small 5V 2A bec
Small momentary switch (i have used one from fpv camera remote)
Futaba style connector for power
Osmo Action Filters (filter glass needs to be heated up and they pop out easily)
Small antenna wire (follow oscar liang tutorial for attaching antenna for wifi)
14x14mm heatsink that is attached from the bottom
Case is made from pla but you can use petg or whatever suits your needs, sensor holder is made from tpu for suppressing any vibrations getting into the sensor/lens.
Flex sensor ribbon is covered with flexi dip (rubber type coat that hold things in place very well and it can be easily peeled off without damaging the connectors, its also good to keep moisture away.
Edit:
I have change the design a bit for longer sesnor ribbon which can be purchased here
https://www.ebay.co.uk/itm/Extension-Connector-Adapter-45Pin-ZIF-0-3mm-Pitch-FFC-FPC-Flexible-Cable-120mm/124447029580
This design does not require previous slightly longer sensor ribbon and stoc one will do the job perfectrly fine and its 3 times cheaper.