Ghost Nightlight by SvobArts

Last crawled date: 5 years, 3 months ago

Small USB nightlight, designed for 5mm or smaller LED
All the electronics are fitted into very little space, it may require a little patience with assembly.
Components

5mm white LED
small switch (its optional)
resistor (based on power source and LED)
USB with 3mm cord diameter

Calculator for right resistor: https://www.digikey.com/en/resources/conversion-calculators/conversion-calculator-led-series-resistor
Print settings:

Opaque parts (holder & tombstone)

layer: 0.16mm
shell thicknes: 1.2mm
infill: 15%
material: grey PLA
raft: no

Translucent parts (ghost)

layer: 0.1mm
shell thicknes: 0.8mm (with every layer less light will go through)
infill: 0% (there is no need for infill it would only block more light)
material: white PLA
raft: yes
support: 20%


There isn't any space for screws, you will need super glue or hot glue.
I personally tied knot with usb cord inside but in retrospective, I should have just glue it inside.
Holder may require a little adjustment for your switch.