Thingiverse
GEPRC LX5 "Leopard" GoPro Session Mount by Zytra
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is a camera mount for the GEPRC LX5 5" Leopard frame.
The overall angle is 35 degrees (accounts for the natural angle of that frame ~ 25 degrees).
It sits right in between the 2 aluminum braces using the oblong holes in the braces to secure itself. The oblong pods have holes for small zip-ties to secure the VTx to it. I found this frame to be relatively small. I use a TBS Unify Pro HV which can heat up so I designed air intake vents on the mount to keep it cool. I had some interference between Vtx and Rx so I relocated the Unify Pro SMA to the GoPro which was far enough from the Rx (and Rx antennas) to get rid of it.
I recommend TPU and 50% in-fill. Use support for it and have the front of the mount sit flat on the build plate. Supports aren't too difficult to clean up.
Edit: I added a version without the rear VTx antenna mount.
https://www.youtube.com/channel/UCRcH4GVpY6f2bHH0l0d6-qA
The overall angle is 35 degrees (accounts for the natural angle of that frame ~ 25 degrees).
It sits right in between the 2 aluminum braces using the oblong holes in the braces to secure itself. The oblong pods have holes for small zip-ties to secure the VTx to it. I found this frame to be relatively small. I use a TBS Unify Pro HV which can heat up so I designed air intake vents on the mount to keep it cool. I had some interference between Vtx and Rx so I relocated the Unify Pro SMA to the GoPro which was far enough from the Rx (and Rx antennas) to get rid of it.
I recommend TPU and 50% in-fill. Use support for it and have the front of the mount sit flat on the build plate. Supports aren't too difficult to clean up.
Edit: I added a version without the rear VTx antenna mount.
https://www.youtube.com/channel/UCRcH4GVpY6f2bHH0l0d6-qA