Gen4 Interface Scripts and Partymode by eried

Last crawled date: 4 years, 1 month ago

Some scripts I like to use with my TOM Gen4 Interface, from the SD card
Contents:
GCODE Folder: Original gcode
S3G-TOM: Build files for my SD
Script folder
Some scripts from http://www.thingiverse.com/thing:11186
S_NozzleS_HBP-Max.gcode: Turn Nozzle and HBP to max temperature 225 and 125 ºC
S_Release.gcode: Release motors to move with hand
S_Calibrate.gcode: First run release, place nozzle centered on the build platform then run this script to save the coordinates
S_Extrude-10s.gcode: Heat nozzle to 225 ºC and extrude 10 seconds
S_Extrude-50s.gcode: Heat nozzle to 225 ºC and extrude 50 seconds
S_Extrude-Rev-10s.gcode: Heat nozzle to 225 ºC and extrude 10 seconds in reverse
S_Extrude-Test.gcode: Heat nozzle to 225 ºC and extrude 10 seconds forward and reverse in a quick small loop (to test the pressure on the filament)
S_Inicial.gcode: Move motors to calibrated 0,0,0
S_Min.gcode: Move motors to upper Z, bottom Y and right X (each endstop)
S_Nozzle-0.gcode: Turn off the nozzle heater
S_Nozzle-225.gcode: Turn Nozzle to max temperature 225
S_NozzleS_HBP-0.gcode: Turn off Nozzle and HBP heater
Partymode folder
Scripts from http://www.thingiverse.com/thing:6964 and http://wiki.makerbot.com/makerbot-music
M_whereisviolin.gcode
M_Zelda.gcode
M_BachInvention.gcode
M_Bolero.gcode
M_gameanthem_xy.gcode
M_Imperial_march.gcode
M_Lullaby.gcode
M_MakerBotMStamper.gcode
M_oneturndeservesanother.gcode
M_openviolin_microprint.gcode
M_PartyLikeACube.gcode
M_snakeydance.gcode
M_Still_Alive.gcode
M_stirringtheair.gcode
M_Tetris.gcode
M_triangleman.gcode