Thingiverse
Geeetech G2 / G2s / G2s Pro Home Position Lock by CJay9209
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a Home lock piece for the Geeetech G2s. A lot of people have issues getting the printer to keep steppers enabled after printing especially with Simplify 3d. This option acts as a backup to make sure that when the printer is given the command to home all axes at the end of the print, even if steppers are disabled, it will hold the spider in the home position rather than have the hot end crash into the printed object.
All 3 trolleys must have the clips installed to be fully effective and function as intended.
I was wanting this done fast so I printed at 0.3 at 80mm/s. Doesn't make for the best quallity but it gets the job done fast haha, so please excuse the poor quallity prints in the picture.
Design by AST
All 3 trolleys must have the clips installed to be fully effective and function as intended.
I was wanting this done fast so I printed at 0.3 at 80mm/s. Doesn't make for the best quallity but it gets the job done fast haha, so please excuse the poor quallity prints in the picture.
Design by AST