Thingiverse
Geeetech E180 Simple Filament Holder by USG
by Thingiverse
Last crawled date: 3 years, 11 months ago
The filament holder is used to hold small amounts of filament wire.
The larger holes are 3.5 mm in diameter.
An M3 thread must be cut in the smaller holes, one at the top at the back and in the button.
I used double-sided tape in the top third of the holder.
The holder can be removed without leaving any residue.
The knob is a remix.
The larger holes are 3.5 mm in diameter.
An M3 thread must be cut in the smaller holes, one at the top at the back and in the button.
I used double-sided tape in the top third of the holder.
The holder can be removed without leaving any residue.
The knob is a remix.