Thingiverse
Gecko DeskPal by ModernGnome
by Thingiverse
Last crawled date: 4 years, 7 months ago
This friendly little gecko looks great on your desk or stuck to a wall with a bit of lightly adhesive putty. Prints at 100% size in less than 30 minutes at standard settings. (it looks great larger, too!) No raft or support is needed on most 3D printers.
It's easiest to remove from the print bed if you slide a palette knife or something similarly thin under the tail and gently work your way forward to get underneath the rear toes, then gently continue forward to the front legs to loosen them.
Update: The feet are now level and completely flat on the bottom.
It's easiest to remove from the print bed if you slide a palette knife or something similarly thin under the tail and gently work your way forward to get underneath the rear toes, then gently continue forward to the front legs to loosen them.
Update: The feet are now level and completely flat on the bottom.