Thingiverse
Geared fidget widget
by Thingiverse
Last crawled date: 6 years, 5 months ago
This is my go at it:
Since I'm not good at modifying STLs, I modeled it from scratch:
slightly smaller than original,
higher tolerances (0.3mm per side)
added gear instead of round side ;-) Real involute teeth with module 1.5
rounded edges
hole in the middle instead of two indents with bridging => more ready to print
champered snap in part for more easy assembly - also longer axis for better stability
Print 6 if the single components and snap together like the original. Assembly is just for viewing; don't think it would work print in place.
Since I'm not good at modifying STLs, I modeled it from scratch:
slightly smaller than original,
higher tolerances (0.3mm per side)
added gear instead of round side ;-) Real involute teeth with module 1.5
rounded edges
hole in the middle instead of two indents with bridging => more ready to print
champered snap in part for more easy assembly - also longer axis for better stability
Print 6 if the single components and snap together like the original. Assembly is just for viewing; don't think it would work print in place.