Thingiverse
gcode to test tronxy X5S, X5SA, PRO by SgaboLab
by Thingiverse
Last crawled date: 4 years, 8 months ago
Hi, most of people have slicing problems .. because they need to learn and this require a bit times :) If you have problems and want test own tronxy x5s, print this alfabetagamma calibration cube .. enjoy
AlfaBetaGamma Cube:https://www.thingiverse.com/thing:2818417
Attention this gcode is valid only for X5S and subsequent models like X5SA/PRO
I sliced with cura 15.06
layer 0.2
infill 20%
top/bottom 0.8
perimeters 0.8
hothead 200°C (for PLA)
--
Photo of printing and other things on youtube in Community-Tab, my new instagram ;)https://www.youtube.com/user/SgaboLab/community
Blogger with some diy guide http://www.sgabolab.com/
Pinshape Shop https://pinshape.com/users/130632-sgabolab
If you think to buy from Gearbest and want support me, use my affiliate link, thanks https://www.gearbest.com/?lkid=14695439
AlfaBetaGamma Cube:https://www.thingiverse.com/thing:2818417
Attention this gcode is valid only for X5S and subsequent models like X5SA/PRO
I sliced with cura 15.06
layer 0.2
infill 20%
top/bottom 0.8
perimeters 0.8
hothead 200°C (for PLA)
--
Photo of printing and other things on youtube in Community-Tab, my new instagram ;)https://www.youtube.com/user/SgaboLab/community
Blogger with some diy guide http://www.sgabolab.com/
Pinshape Shop https://pinshape.com/users/130632-sgabolab
If you think to buy from Gearbest and want support me, use my affiliate link, thanks https://www.gearbest.com/?lkid=14695439