Gazebo Joe

Last crawled date: 7 years, 2 months ago

Gazebo JoeUsed GIMP to make textures save for one of rod iron fence.Textured set to fit all quads for this look of some. Unwrapped and reset. Some have seams too but you can set as you wish. All directions are given while in orthographic view. How I set this up is to pick the dome you want from layer 14. select the dome and then duplicate it shift d, the esc or right mouse button. Now press m and select layer 1. This will move the new copy of the dome the layer 1. Move to layer 1, shift c or shift s and set cursor to center and selected dome shift s and Selection to Cursors. Now it is in the center. Scale it to desired size, use n in 3D view for Transforms: Dimensions: and set your x and y (same value for round). Select a pillar from layer 19. They can be stacked, what ever you want select and duplicate as you did with the dome. Move them to layer 1. Arrange pillar(s) in center as dome. Scale as desired, then in top view (7 number pad) using snap or control for even increments position the pillar(s) to the out side of your dome, x or y. You may want wire frame for better placement and view. With the first pillar in place make sure cursor is in center and duplicate pillar. Set the Pivot Point to 3D Cursor. Press r to rotate 180 Enter. Now there are two pillars. Select all pillars and duplicate, Press r to rotate 90 Enter. Now there are four. If you select all pillars again, duplicate and rotate 45. now there are 8. there are other items her in other layers. Rails seats working on them but thought I would share what is ready now. Good Blending Artists. :) Comments welcome will be working on the table, benched and seated sections.