Thingiverse
Garmin Fenix3 Workstand by Scux
by Thingiverse
Last crawled date: 4 years, 3 months ago
I own a Garmin Fenix3 and ha a few different watch band straps, steel, leather and rubber. I found it annoying to loosen and tighten the screws without support. It was easy to damage the screws.
The workstand is making the loosening and tightening of the screws easier by aligning the screwdrivers and keeping them in a straight line. In this way the screws will survive tightening/loosening longer.
The rib is low enough so that the workstand could be used when replaceing the crystal or the bezel.
When replacing the watch band its good to know that the dots in the BERGSLÖPARNA logotype indicates the direction of the strap with with a buckle on it. It always confuses me...
The workstand is making the loosening and tightening of the screws easier by aligning the screwdrivers and keeping them in a straight line. In this way the screws will survive tightening/loosening longer.
The rib is low enough so that the workstand could be used when replaceing the crystal or the bezel.
When replacing the watch band its good to know that the dots in the BERGSLÖPARNA logotype indicates the direction of the strap with with a buckle on it. It always confuses me...